Question Ozmosis

Hi sin0w,

take a look at the attached Standard_Defaults_eng.plist,
It contains some explanations about where to get the infos you need to put in.

In regards to the bootargs "nv_disable=1" and/or "nvda_drv=1", you have to put those into the following part of the file:

If you have issues to install with installed Nvidia card, remove it until the installation is finished and you're able to install the Nvidia Webdrivers.

If you edit the attached file as mentioned in the file and put it into the directory /EFI/Oz on your hidden EFI-partition, rename it to "defaults.plist", reboot to your BIOS and do an NVRAM-Reset by using the key combo "Alt+WinLogo+P+R".
This will reboot the machine and reload all Ozmosis addins plus the new defaults.plist.
Your iMessage should work afterwards, if you didn't mess up anything in the file...

Just post your situation/issue and I will try to help.

I guess you forget to do the NVRAM Reset to make sure the new Defaults.plist will be loaded.
you can do that by boot into the BIOS and use the keyboard combination "Alt+WinLogo+P+R".
The Machine will do a reboot and loads Ozmosis and the Defaults.plist from scratch.

The big issue will be that all your manually added settings in NVRAM will be lost with the NVRAM Reset.
On the other hand the Defaults.plist will never be used if you do not do the NVRAM Reset.

It's your choice...

Yes,
the Defaults.plist must be put into /EFI/Oz

That information doesn't help...
What is the current situation?

You did put the Defaults.plist into the directory /EFI/Oz on the hidden EFI-partition?
Did you do the mentioned NVRAM-Reset while in BIOS (Alt+WinLogo+P+R)?
Can you boot your system?
Are you in OSX right know?
What is the current Systemdefinition which is shown in SystemInformation/SystemProfiler?

Click on the Apple logo in the left corner of your screen, click "about this Mac" and the the Button "System Report".
That should lead you to the following screen:

Make a screenshot and post it here

Lol attach your ROM and your Defaults.plist
Or sent me your Defaults.plist in PM since I see you us iMessages.
And I try to help you!!!

Yes here and look your PM. I hope this work for you and you understand what I say.
Good luck.

Answer of @sin0w in PM:

Zitat

Thanks works.

Question;

1-my old system iMac 14.1 ( new MacPro3.1) Default.plist Edit?
2-My old system imessage work ( new system does not work) default.plist where and what should I write code?
3-My Garphics card now 2989 MB GTX970 work ( old 4890 MB) edit?
4- Bıos open XMP ( 8 GB ram 1600 Mgh ) now 1333 mgh edit ?

I would be glad if you answer these questions now

Thanks.

Alles anzeigen

I give you command for disable NVidiaInjection. For RAM go to M.I.T. aud put mempry to Profile1.
Definition of smbios have in PM and for iMessage look do you changed Hardware Address.