Good day,
I've encountered a problem with oz and z97hd3.
While I mod bios with oz (or using one from forum) it working like it should be, until I install msi gtx 1050ti. After bios flash process, after first boot, the motherboard just freez. Nothing helping except power btn reboot.
My current rig:
Xeon e3 1245 v3
Z97hd3 (v2)
Msi gtx 1050ti
This rig works with windows 10 without a problem, clover - so far so good, but any kind of oz- nope.
Before what I did:
Tried update cpu micro codes with bios.
Update graphics card GOP drv
Contacting gigabyte support, they suggested that this is a socket problem. While people from service were inspecting socket screwdriver fall into the socket, so they repaired couple bend pins. Rig still working with windows 10 without a problem.
So now I'm out of options, ready to buy new motherboard.
The reason I'm asking about this, is only about that I want to know, this is hardware problem, or some parts are not supported? Maybe someone encounter similar problems, or this is z97 chipset problem. Tomorrow I will meet the guy with z97x-ud3h, so before purchase it, I would like to know, will it work.
Thank you!
10.13 gtx 1050ti and ga z97hd3 problem.
-
- Erledigt
- firefly_can_fly
- Erledigt
-
-
Hi @firefly_can_fly
nice to have you here...In regards to your setup, there are a couple of things that should be checked to get your 1050TI running.
- Do you use a Defaults.plist in your hidden EFI-partition under /EFI/Oz?
- If so, does it contain the necessary parts likein Defaults:1F8E0C02... or
in <key>Defaults:7C43611
- Does your ROM contain the newest FakeSMC including all the Sensor kexts? (FakeSMC_GPUSensors are known to lead to crashes with Pascal cards) -
Sorry for late reply,
That motherboard been working unpredictably, so when i was messing wth cooling - pins been damaged and even after the repairs it was still working not okay. Because when i put graphics card in it - it freezes even before the boot (in bios) and as I not good into understanding Ozmosis and how in works under the hood - i went and bought new motherboard z97x-ud3h, currently trying to make it work with Xeon Cpu and clover. Maybe after would go for Ozmosis once again. -
Hier geht es nicht mehr weiter. Der TE hat das Board nicht mehr.
The Thread Ends, the Thread Owner do Not have the Board anymore.
Gruß Mocca55