Hello! Trying to install 10.11.6. The flash drive started up for the first time, the installation went through. After installation for the second time, there is no bootable hard drive in the clover. I tried to insert a HDD into sata Intel (not Marvell), it did not work.
Legacy BIOS Problem with disk.
- v1ta
- Erledigt
-
Hallo,
you can upload your EFI as zip-file here. Perhaps wie can help.
Good luck
-
Hello,
on the Internet I found the following:
https://mcdojf.wixsite.com/z68x/macos-10-15-catalina
Maybe you can do something with it.
Good luck
-
The fact is that there is no UEFI for my board.
You used ozmosis on your Z68, it Has UEFI, because ozmosis only works on UEFI motherboards. Die Mac-Installation wird nicht gestartet.
This means you should be able to use Uefi Boot on your motherboard (and also could use opencore).
-
Hello,
here I found a Bios update:
https://drivers.softpedia.com/…-B3-rev-13-BIOS-F12.shtml
This should actually fit
(Flash Bios with it, but at your own risk)
hopefully it works
-
Not sure if it the same problem, as i had with my first Hackintosh. It was the same. I booted from USB Stick, installed everything. Copy the EFI to the SSD, but can´t boot. I need to run LegacyBoot command. After that, it started.
-
thahahmmer I set it through Clover, OpenCore got stuck on an error with "bluetooth", unlike Clover.
I think I should try creating a Clover USB Installer for MBR Booting.
I think this processor needs that. Its so long ago i made my first Hackintosh with clover
