hier die efi mit Kext aktiviert

sorry bei terminal use. bin ich raus XD

Ich komm grade nicht mehr mit. Läuft den MacOS schon bei dir? Weil TINU ist für MacOS und nicht für Windows.

Ahh, das ist cool.

Wenn der Stick fertig ist, die EFI Partition vom Stick mounten und den EFI Ordner von Hecatomb da rein kopieren

pegxa could you post EFI you are using by now?

Magic symbol error means an old kext used in EFI (not good for Ventura)

use the attached one

also a new SMCAMDProcessor kext just be updated if you are using it

your motherboard (MSI AMD Board)needs a bit of more effort to boot OSX from Monterey to Sonoma OS

but you can install all system you like

thanks Master Sun XD

Kext ist drin...der quirk aber nicht gemacht...

Einfach testen. Kann ja nichts passieren

Change completely with this EFI (based on Hecatomb one)

Have you done USB port mapping properly for your motherboard?

if also with my EFI hangs like before try this config (with my EFI)

Fix bus enumeration problems also some MSI board could have

I see kexts for USB mapping , they should be adapted for your motherboard needs

MD BIOS Settings

• Note: Most of these options may not be present in your firmware, we recommend matching up as closely as possible but don't be too concerned if many of these options are not available in your BIOS

#Disable

• Fast Boot
• Secure Boot
• Serial/COM Port
• Parallel Port
• Compatibility Support Module (CSM) (Must be off in most cases, GPU errors/stalls like gIO are common when this option is enabled)
• IOMMU

Special note for 3990X users: macOS currently does not support more than 64 threads in the kernel, and so will kernel panic if it sees more. The 3990X CPU has 128 threads total and so requires half of that disabled. We recommend disabling hyper threading in the BIOS for these situations.

#Enable

• Above 4G Decoding (This must be on, if you can't find the option then add npci=0x3000 to boot-args. Do not have both this option and npci enabled at the same time.)
  • If you are on a Gigabyte/Aorus or an AsRock motherboard, enabling this option may break certain drivers(ie. Ethernet) and/or boot failures on other OSes, if it does happen then disable this option and opt for npci instead
  • 2020+ BIOS Notes: When enabling Above4G, Resizable BAR Support may become an available on some X570 and newer motherboards. Please ensure that Booter -> Quirks -> ResizeAppleGpuBars is set to 0 if this is enabled.
• EHCI/XHCI Hand-off
• OS type: Windows 8.1/10 UEFI Mode (some motherboards may require "Other OS" instead)
• SATA Mode: AHCI

#

mach die ssdt aus und den Kext wieder an.