Beiträge von mokapuccino

Okay,

for my restart problem after a shotdown, is it a hardware problem according to you?

thanks

Hi everyone

I have some problems with my hackintosh.

First, when I turn off the hack completely and want to turn it on again, it runs in a vacuum with a black screen.

not even an Asus bios, nothing.

to turn it on again I have to force it to turn off by keeping the power button pressed.

then at the second ignition it boots normally but the bios starts in safe mode.

Why ??

second, my thunderbolt card is well recognized by IORegistry except that it does not appear in "system report" "thunderbolt : No driver loaded.".

and of course when I turn off the hack and want to turn it on again (it needs to be turned on twice for it to run properly) the thunderbolt card is no longer recognized.

Probably because of bios safe mode

thank you for your possible lights

Ok 😅

Stupid mistake

Everything is working properly now.

But when I want to put the Thunderbolt card on pci 2, I have to put the graphics card on pci 3 port and there I have a black screen.

When the graphic card is on pci 1 everything is ok.

I have a Radeon VII

No it’s enp179s0f0 😅

Yes, I search on internet, just reboot and re launch ubuntu key again and now, it’s seem interfaces are recognize.

I don’t know why 🤦🏻

Now, I’m on step 5 (sudo ethtool -e enp225s0f0)

I can’t do futher that step

DSM2

I’m on my way for 10g

OS X was installed

I boot ubuntu from the key.

Write commands lines on terminal but there is So many error during process

What did I do wrong ?

Thanks for help

Hi,

I’m already on my hack install.

Since 2 days, I can’t go futher than this step « end randomseed »

Q-code of motherboard is « 61 » —-> nvram initialization

I try differents methods with (emuvariableuefi or osxaptiofix) with no results

bit thanks for your help

Sorry for picture, it’s automaticaly reverse, I can’t fix 😅

Ok, I just switch to an other m2 port and it’s fine !
thanks a lot

kaneske

When I restart whitout key Ihave nothing on my asus boot.

With the key, asus bios show me my uefi partition (on my key)

its seem bios çan’t fond my nvme storage

g-force

I tried your option but it’s still same

I can only boot with my key

ASUS bios can’t show me my nvme uefi (apfs partition) ... 😕

kaneske
Hi,

I create my own ssdt with clover (f4) on bootloader and I make that on my folder « patched »

Install works very Well and now I m on desktop.

Transfer efi folder on catalina install nvme is ok

But when I restart, bios can’t see my uefi on nvme apfs.

I can boot only with my key

Do you have any ideas ?

thanks a lot for your Time

ok I skipped that

I upload SSDT to EFI

but when I boot on my key I have the same result.

hackintosh-forum.de/attachment/154023/

thks,

I followed each steps of your guide.

but I still have the same issue that's why I tried to add some rules and preferences but I can't fix it.

I just made a fresh install on my key and followed your guide.

same result.

thanks you very much for your help

Hi everyone,

It's my first post.

I followed the steps for install osx Catalina.

I flashed the bios to 3203

but actually, I stay stuck at this point (screen)

I don't understand what to do.

thanks for your time